![]() However if it's caused by a failing drive it may happen again, so if you restore the Cloud Key, download a config backup immediately and if it fails again, consider replacing the drive. Note: "Check Filesystems" will run a fsck on all partitions and potentially fix the issue. From here you can reset, reboot, power off, check filesystems, and upload an updated firmware bin file. You should be taken to the Recovery Mode screen.However, keep in mind that if your Cloud Key does have a IP address assigned by the DHCP server, the fallback IP will not work. The IP address comes from your DHCP server, if you can't access DHCP, the fallback IP will work: 192.168.1.30. Once the LED is flashing in the recovery mode pattern, open your browser and type the IP address for the Cloud Key, visible on the device's screen.The LCD screen on the front panel will also read "RECOVERY MODE." Keep the reset button pressed for about 10 seconds, or until you see the recovery LED pattern in a loop (blue - off - white).Press and hold the reset button and then power on the Cloud Key by connecting it to the power source.To access this interface you will need to know the IP address of the Cloud Key (visible in the device screen).įor second generation Cloud Keys (UCK-G2 and UCK-G2-PLUS) follow these steps to access the Emergency Recovery UI:.Use the left hand menu to select the correct Cloud Key model and find the newest firmware available. To upgrade the firmware, you will need to download a firmware file (.bin) for the Cloud Key found in our Downloads page. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |